Skip to content

GitLab

6.Let's assemble · Changes

Page history
Add tolerance value of plus minus 2 mm to center the blades. authored by immanuel ernix's avatar immanuel ernix
Hide whitespace changes
Inline Side-by-side
6.Let's-assemble.md
View page @ 41c07bf8
......@@ -164,13 +164,7 @@ Repeat the last steps with the two other blades
### Measure and center the blades
Measure and write down the distance of one tip of the blade to another. After the first measurement, adjust the blades by unscrewing the outer blade fasteners, move the blade and re-tighten the fasteners. Repeat this process until you have a satisfying result.
| Distance | 1. Measurement | 2. Mesurement | 3. Measurement |
| -------- | -------------- | ------------- | -------------- |
| A - B | X cm | X cm | X cm |
| B - C | X cm | X cm | X cm |
| C - A | X cm | X cm | X cm |
Measure and write down the distance of one tip of the blade to another. After the first measurement, adjust the blades by unscrewing the outer blade fasteners, move the blade and re-tighten the fasteners. Repeat this process until you have a satisfying result of all three blade tips beeing at a distance of plus minus 2 mm to each other.
![MainAssembly.windkit_30](img/MainAssembly/MainAssembly.windkit_30.png)
......@@ -207,5 +201,4 @@ Use the Vane Fastener to attach the Vane
### Install the Cable
TODO
Install the cable with the generator plug trough the tower and the cable gland. Connect the plug to the generator. Tighten the cable gland.